CAR ALARM AND REMOTE START INSTALLATION GUIDE
Copyrght 2002-2004 Triple S Customs 48
ADDING DOOR LOCK ACTUATORS
• Vehicles without factory power door locks require the installation of an actuator in each door.
• This requires mounting the door lock actuator inside the door. The fuse used on 12V inputs should be 7.5A
per motor.
• To install door lock actuators the door panel must be removed.
• Most actuators come with mounting instructions. Read and carefully follow all directions.
• Locate the metal rod that moves when the doors are locked or unlocked. Notice how it moves when the locks
are locked and unlocked. The actuator needs to be mounted so that it can pull and push that rod to lock and
unlock the door.
• The actuator should be mounted in a way that it moves parallel to the locking rod of the door.
• The actuator must be mounted so that the door panel can be reinstalled without interfering with movement of
the door lock actuators, windows, or the door handle.
• Some good spots are located towards the rear of the door
• Carefully wrap all wires and run them into the car.
To Next Page
Loading...