19
T150Z pumped thermostatic electric shower
OPERATING THE SHOWER
When the electricity supply to the shower is
switched on at the isolating switch, the “power
on” indicator will light.
To start the shower
Press the start/stop button and water will flow.
After a few seconds, a flow of heated water will
be available (fig.21).
To stop the shower (manually)
The shower can be stopped by pressing the
start/stop button. When pressed, the phased
shutdown will begin and water will cease to flow
after a few seconds(fig.21).
To stop the shower (timed Shutdown)
Shutdown times can be set at 5, 10, 20 (factory
setting) or 30 minutes. When the indicator
illuminates it indicates there is 1 minute before
the timed shutdown will turn the shower off.
Start/Stop
button
Fig.21
WARNING!
This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to
ensure that they do not play
with the appliance.
To Next Page
Loading...
Need help?
General
