T30i
2
ADVICE TO USERS
The following points will help you understand
how the handwash operates:
a.
The electric heating elements operate at
a constant rate. It is the flow rate of the
water passing through the heater can which
determines the water temperature at any
given setting. (The slower the flow, the
hotter the water becomes and the faster the
flow, the cooler the water).
b.
During winter, mains water supply will
be cooler than in summer. Therefore the
water temperature of the unit will vary
between seasons on any one setting of
the temperature control, e.g. if you have
chosen setting number 6 as your preferred
handwash temperature in the summer, you
may have to increase that number during
winter by adjusting the temperature control
anti-clockwise (which in effect slows the
water flow).
c.
The stabiliser valve minimises variations
in water temperature during mains water
pressure changes. If changes in water
temperature are experienced during normal
use, it will most likely be caused by the
water pressure falling near to or below the
minimum level. The drop in pressure may be
due to water being drawn off at other points
whilst the unit is in use. If the pressure
drops appreciably below the minimum, the
heating elements will automatically cut out.
DO NOT place items such as soap or shampoo
bottles on top of the unit. Liquid could seep
through the joint between the cover and
backplate, and possibly damage the sealing
rubber.
If water becomes too hot and you cannot
obtain cooler water, first check that the
sprayhead is not blocked.
INTRODUCTION
This book contains all the necessary fitting
and operating instructions for your Triton
T30i electric handwash unit. Please read them
carefully.
The installation must be carried out by a suitably
qualified person and in the sequence of this
instruction book.
Care taken during the installation will ensure a
long, trouble-free life from your handwash.
SPECIFICATIONS
Electrical
Nominal power Nominal power
rating at 240V rating at 230V
3kW – 13A 2.7kW – 13A
7kW – 30A 6.5kW – 30A
Water
Inlet connection – 15mm diameter.
Outlet connection – ½” BSP male thread.
Entry Points
Water – bottom.
Cable – top, bottom or back.
Materials
Backplate, cover, control knobs – ABS.
Elements – Minerally insulated corrosion resistant
metal sheathing.
Dimensions
Height – 173 mm
Width – 200 mm
Depth – 108 mm
Standards and Approvals
Splashproof rating IPX4.
Complies with the requirements of current
British and European safety standards for
household and similar electrical appliances.
Complies with requirements of the British
Electrotechnical Approvals Board (BEAB).
Meets with Compliance with European
Community Directives (CE).
Replacement parts can be ordered from Customer
Service. See ‘spare parts’ for details and part numbers.
To Next Page
Loading...
Need help?
General
