13
CONSOLE FUNCTIONS
FUNCTION BUTTON:
MODE: This key allows you to select and lock on to a particular function.
AUTO ON/OFF: The system turns on when any key is pressed or when it receives an input
from the speed sensor. The processor turns off automatically when the
speed sensor has no signal input or no key is pressed for approximately 4
minutes.
RESET: The unit can be reset by changing the batteries or pressing the MODE key
for 3 seconds.
MODE: Use this to select the SCAN mode or to LOCK onto specic data if you do
not want to use the scan mode. To do this, press the MODE key until the
arrow points towards the function you want.
FUNCTIONS AND OPERATIONS:
TIME: Press the MODE key until the arrow points towards TIME. The total working
time will then be shown as soon as your exercise starts.
SPEED: Press the MODE key until the arrow points towards SPEED. The current
speed will then be displayed.
DISTANCE: Press the MODE key until the arrow points towards DISTANCE. The distance
of your workout will then be displayed.
CALORIES: Press the MODE key until the arrow points towards CALORIES. The calories
burnt will then be displayed as soon as you start your exercise.
ODOMETER: Press the MODE key until the arrow points towards ODOMETER. The total
accumulated distance will then be shown.
SCAN: The display will automatically change every 4 seconds.
BATTERIES: This Console takes 2 AA batteries. Should you not be getting a clear
readout, replace the batteries.
SPECIFICATIONS:
TIME (TMR) 00:00 - 99:59
SPEED (SPD) 0.0 - 99.9 KM/H
DISTANCE (DST) 0.00 - 999.9 KM
CALORIES (CAL) 0.00 - 9999 CAL
ODOMETER (ODO) 0.00 - 9999 KM
#19M05T013 Apex 100 Bike UM V2.indd 13 15/07/2019 14:05
To Next Page
Loading...
Need help?
General
