1569-13
9. FREQUENTLY ASKED QUESTIONS
Q1. My elliptical does not move as easily as indicated in manual
1. Ensure you have placed the stabilizer with the wheels in the front of the unit.
Q2. My consol does not work?
1. Make sure you have connected it correctly and have placed the batteries in the consol.
Q3. My consol is not clear and appears faded?
1. Ensure your unit is not in direct sunlight and you have removed the plastic cover from the screen.
If display does not improve, please contact 0861 876 526
Q4. My tension control is not working?
1. Ensure the cable has been connected correctly
Q5. My pedals are not fitting properly?
1. Make sure you have inserted them on the correct side of the unit. Each pedal is marked L or R.
Q6. I cannot thread the main cable through the upright bar?
1. Use the thin wire provided or a piece of string to assist you.
Q7. My consol is showing a “0” error
1. Check that the sensor magnet is correctly fitted and passes in front of the sensor.
2. Check the gap between speed sensor and the magnet is 5mm or less
3. Check that all computer plugs and sockets are firmly and correctly connected
4. Check that the computer wires are not damaged
If the error persists, please contact 0861 876 526
Q8. The consol cannot read the hand pulse signal
1. The hand pulse sensors will not operate correctly if your skin is extremely dry. Moisten your hands and try again.
2. Avoid moving your hands while exercising and hold the hans pulse sensors firmly while exercising. If you do move your
hands while exercising, give the computer a few seconds to resample and display your correct heart pulse rate
3. Clean the hand pulse sensors to ensure good contact between your body and the pulse sensor
If the error persists, please contact 0861 876 526
To Next Page
Loading...
Need help?
General
