Trojan MOTION 360 - Maintenance; Lubrication Procedure and Schedule; Belt Tracking Adjustment

19
10322

HOW TO APPLY LUBRICANT
• Liftonesideofthetreadbelt.
• Pouronehalfofthelubricantbottleunderthecentreofthetreadbeltonthetopsurface
of the treadboard.
• Walkonthetreadmillataslowspeedfor3to5minutestoevenlydistributelubricant.
• NOTE:DONOToverlubricatetreadboard.Anyexcesslubricantthatcomesoutshould
be wiped off.
• NOTE:ONLYUSEHALFTHEBOTTLEOFLUBRICANTPERAPPLICATION.
• NOTE:Ifyourlubricantisnished,thetreadbeltcanbelubricatedwithDubbin.
LUBRICATION SCHEDULE
• Checkthetreadboardlubricationduringinstallation.Ifit’snecessary,lubricatethe 
treadboard using one half of the lubricant provided, before using the treadmill for the
rst time.
• Ifthetreadmillisusedonaregularbasis,therunningdeckshouldbelubricatedoncea
month.
• Ifthetreadmillisnotusedfortwomonthsormore,thetreadboardmustbelubricated
before use.
BELT TRACKING ADJUSTMENT
• Ifduringuseyounoticethattherunningbelt
either shifts to the right or the left of centre,
switch off the treadmill, remove the “Safety Key”
and unplug the equipment from the AC power
source.
• Iftherunningbeltshiftsleft,usingAllenKey 
provided, turn the left rear roller adjustment
clockwise no more than 1/4” of a turn (if
the running belt shifts right, adjust the right rear
roller).
• RemovetheAllenKey,insertthe“SafetyKey”
and insert the AC power cord into the
AC outlet. Turn on your treadmill and observe
after running for a few minutes to see if
the problem has been corrected.
• Thismaytakeseveraladjustments,sorepeatthe
above procedure.