NOTE:
Do not touch any internal electric wires without consulting the manufacturer.
TREADMILL WILL NOT START:
• Make sure the power cord is plugged into a surge protector, the surge protector is plugged into a properly grounded
outlet and the surge protector is turned on (refer to the Power Requirements section in this manual).
• Check the circuit breaker reset switch located on the front of the treadmill. Turn the treadmill off, wait 5 minutes then
turn on the treadmill and press the rest switch.
• Check the house electrical breaker box and the circuit breaker it is located in. If it has tripped, reset or have an electrician
replace the breaker in your home.
• Have an electrician check for inadequate voltage at the outlet.
TREADMILL LOSES POWER DURING USE:
• Have an electrician check for inadequate voltage at the outlet.
• Check the house electrical breaker box and the circuit breaker for the room the treadmill is located in. If it has tripped,
reset or have an electrician replace the breaker in your home.
TREADMILL WALKING BELT SLOWS DURING USE:
• Check to make sure the treadmill is securely plugged into a UL-listed surge protector, rated at 15 amps, with a 14-gauge
cord of ve feet or less and the surge protector is securely plugged into the outlet.
TREADMILL WALKING BELT SLIPS OR IS NOT CENTERED ON REAR ROLLER:
Refer to Belt Adjustment section of this manual.
PROBLEM SOLUTION
To Next Page
Loading...
