1061M-14
ASSEMBLY STEPS (BENCH)
STEP 03
• Fasten the Seat Cushion (A9) onto the Main Frame (A1), secure them with four 1/4” x 1/2” Bolt (A20) and four
1/4” x 14mm Washers (A25).
• Attach the four 25mm Square Cap (A12) onto both sides of the two Cushion Tube (A5).
• Connect both Cushion Tubes (A5) with the round tube on the Main Frame (A1).
• Attach the Adjustable Bar (A6) onto both two Cushion Tubes (A5).
• Connect the Back Cushion (A8) with two Cushion Tubes (A5), secure them with the two 14” x 1-3/8” Bolt (A19)
and four 1/4” x 14mm Washer (A25).
• Connect the Bracket (A7) with the Adjustable Bar (A6), secure them with one 8 x 40mm Bolt (A18)
two 5/16” Washer (A26) and one 8mm Nut (A23).
• Connect the Bracket (A7) with the Main Frame (A1).
• There are 4 holes on the Main Frame (A1), so you can adjust it into 4 different positions by adjusting it with the
8.7mm x 55mm Pin (A22).
Round Tube
To Next Page
Loading...
