7815-10
COMPUTER FUNCTIONS
OPERATING INSTRUCTIONS
1. Plug in the power
2. Plug the adaptor into the equipment or insert batteries in the back of the console then the computer will
produce a beep sound and then turn on in Manual mode.
When you reach the target, the computer will sound an alarm and then stop.
If you set up more than one target and you would like to reach the next target, press START/STOP key to
keep on exercising.
OPERATING GUIDE
The computer will enter CLOCK setting mode when you switch the power on. You can set up the current time by
pressing the UP or DOWN keys to adjust hours and minutes.
Clock Mode:
a. The computer will enter the CLOCK mode when there is no signal input or no keys have been
pressed for 4 minutes. You can press ENTER key to switch between clock and temperature at
clock mode or press any other key to quit the clock mode.
b. You can set the CLOCK by holding the ENTER key for 2 seconds then adjust by pressing the UP or
DOWN keys.
c. By holding the ENTER and UP keys together for two seconds, you can check the current clock during
“NO SPEED” mode.
BATTERY REPLACEMENT
1. Please place 4 size C batteries in the battery case on the back of console.
2. Ensure that the batteries are correctly fitted.
3. Whenever batteries are removed, all the values will reset to zero.
To Next Page
Loading...
