7815-6
4. ASSEMBLY STEPS
STEP 01
• Attach the Front Stabilizer (14) and the Rear
Stabilizer (13) to the Main frame (1) using Bolts
(37), M8 Spring Washer (11) and M8 Washer (10)
STEP 03
• Remove three M8 Nylon Nuts (57) and three M8 Washers (65)
from the bottom of the Seat (12)
• Attach the Seat (12) to the Seat Post (32) with three
M8 Nylon Nuts (57) and three M8 Washers (65)
• Place Plastic Collar (66) over Seat Post (32) then insert
the Seat (32) into Main Frame (1)
• Adjust to the desired height with the Seat Knob (24)
STEP 02
• Connect the Upper Computer Cable (16) to the Servo
Motor Cable (17) on the Main Frame (1) .
• Attach the Front Post (22) to Main Frame (1) with four
Allen Head Screws (23), four M8 Spring Washers (11)
and four M8 Washers (10)
CAUTION:
Ensure that cables are not damaged
during assembly or when tightening screws.
1
1
To Next Page
Loading...
