1574-13
STEP 6
• Attach Butterfly Mount (19) to Front Upright (7) using 2-1/2”x3-1/4” Hex Bolts (92) 4-1/2” Washers (87) 2-1/2”
Locknuts (84).
• Attach left/right Press Frame (4, 5) to Butterfly Mount (19) using 4-Copper Bushings (62) 2-Big Washers (90)
2-1/2”Locknuts (84).
• Attach two Hand Tube (21) to left/right Press Frame (4, 5) 4-Copper Bushings (62) 2-Big Washers (90) 2-1/2”
Locknuts (84) 2-1/2” Plastic Dome Caps (103)
• Attach Leg Extension (20) to Seat Support Frame (11) using 1- 3/8”x2-7/8” Hex Bolt (76) 2-3/8” Washers (86) 1-3/8”
Locknut (83) 2-3/8” Plastic Dome Caps (102).
• Install one 3/8”x2-3/8” Hex Bolt (78) to lower hole of Leg Extension (20) using 2-3/8” Washers (86) 1-Long Busing
(107) 1-3/8” Locknut (83) 2-3/8” Plastic Dome Cap (102)
• Insert Short Foam Rod (23s) into holes of Leg Extension (20) and press two Foam Rolls (32), Round Caps (60)
onto Short Foam Rod (23s).
ASSEMBLY STEP
.
5
4
52
56
21
62
62
84
90
62
62
90
84
92
87
50
19
50
87
84
32B
60
23S
20
86
83
86
78
32B
60
83
86
86
76
11
52
102
102
102
102
103
55
107
To Next Page
Loading...
