Trojan POWER STACK 500 - STEP 9

1574-16
STEP 9
• Install Lower Cable (69) as shown.
• Install Pulley no. 9 to unit using 1-3/8”x2-3/8” Hex Bolts (78) 2-Little Bushings (68) 2-3/8” Washers (86) 1-3/8” Locknut
(83) 2-3/8” Plastic Dome Cap (102).
• Install Pulley No 10 to Seat Support Frame (11) using 1- 3/8”x4-1/4” Hex Bolt (72) 1-Middle Bushings (67) 1-Pulley
Hook (42) 2-3/8” Washers (86) 1-3/8” Locknut (83) 2-3/8” Plastic Dome Cap (102).
• Install Pulley no. 11, 12, 13 To Unit Using 3- 3/8”x2” Hex Bolts (80) 6-3/8” Washers (86) 3-3/8” Locknuts (83)
• Install Pulley no. 14 to unit using 1-3/8”x2-1/2” Hex Bolts (77) 2-Middle Bushings (67) 2-3/8” Washers (86) 1-3/8”
Locknut (83).
• Attach Hand Grips (54) to Curl Bar (22).
• Attach Curl Bar (22) to Ball end of Lower Cable (69) using 2-Chain Hooks (45) 1-Long Chain (38)
• Attach Ab Strap (29) to Little Ball End of Lower Cable (69)using 1-Chain Hook (45)
ASSEMBLY STEP
STEP
9
12
13
14
29
83
86
67
77
86
45
31
80
69
69
2
86
46
86
83
102
86
67
72
102
42
46
11
7
83
86
102
102
30
80
86
83
86
46
69
33
34
54
22
45
38
45
78
86
68
68
86
83
46
69
80
86
83
86
46
31
20
9
10
11