3. ASSEMBLY STEPS
STEP 01
Attach the Front Stabiliser (7) to the Main Frame with 2 Allen-Head
Screws (18), 2 Washers (30), 2 Spring Washers (31) and
2 M8 Cap Nuts (35).
STEP 02
Attach the Rear Stabiliser (8) to the Main Frame with 2 Allen-head Screws (65),
2 Spring Washers (31) and 2 Washers (30).
STEP 03
Connect the Computer Wire (78) to the Sensor Wire (79) on the Main
Frame (1). Connect the Tension Control (75) to Tension Connector (76).
Refer to the illustration at the top left of the picture. Attach the Front Post (2)
To Main Frame with 3 Allen Head Screws (20), 3 M8 Spring Washers (31) and
3 M8 Washers (30).
CAUTION:
Ensure that cables are not damaged during assembly or
when tightening screws
To Next Page
Loading...
