Trojan WALKER 110 - Computer Functions; General Operation; Operation Modes

10200-11
8. COMPUTER FUNCTIONS
I. GENERAL OPERATION:
1. Turn on the treadmill.
 2.Putthesafetykeyintherecessoftheconsol.
The beeper will sound, and all the windows will display values. The initial values are 0, and do not flash. This means the
treadmill is in the START/READY mode. In this mode the user can hold the grip pulse sensor to detect heart
rate values.
 **Ifthesafetykeyisnotplacedintherecessoftheconsol,theTIMEwindowwilldisplay“-------”indicatingthetreadmillcan’tbe
operated normally.
 **Duringaworkout,ifthesafetykeycomesoff,thebeeperwillsoundawarningandthetreadmillwillstop.Torestart,
  putthesafetykeybackintotherecessoftheconsol.Allthevalueswillrevertbacktotheinitialvalues.
** Under the START/READY mode, if you do not hold the Hand Pulse Sensor, then the PULSE window will display
HP. When the user holds both sides of the Hand Pulse Sensors, the PULSE window displays the heart rate values.
** PULSE value range: 40~240 beats/min.
** Refer to table on page 15 for different age and heart rate values.
II. OPERATION MODE:
1. Under START/READY status, press tostartthetreadmillatthespeedof1.0km/hr.Press or
to increase or decrease the speed. When the user presses the treadmill will stop. Press once and all
thevalueswillstopchanging,andthetreadmillwillpausefor4minutes,thenitwillrevertbacktotheSTART/
READY position. If the user presses and holds it for 3 seconds, it will reset to the START/READY position.
2. Under START/READY status, press or to select the program setting and press to preset
the function values.
3. Program mode: Press or to choose a Program from P0~P6 and the PROGRAM window will start
flashing. Press to move to the LEVEL option. The LEVEL can be set at L1~L3 and you can change it by
pressing or . After confirming the LEVEL, press to move to the TIME option.
The initial manual TIME value is 20min and the initial program TIME value is 32min,with a range of 5 ~ 99 min ,
and increments of 1 minute. After setting, press to start. If the user presses the keyduringsetting,
the rest of the unset functions will adopt the initial values.