REFRIGERATED FOOD PREP
TEC_TM_090 | REV. C | EN 12/13/2022 Page 17 of 24
www.truemfg.com
Maintenance, Care & Cleaning (cont.)
Lid Maintenance
The lid pin screws are designed to be removed for cleaning.
Remember to periodically check the screws and ensure they are
tight. See lid pin screw locations below (figs. 1-4).
Fig. 1. TSSU (inside).
Fig. 3. T PP.
Fig. 2. TSSU (outside).
Fig. 4. T PP.
Composite Cutting Board Maintenance
Please see the message from Richlite® regarding composite cutting
boards material and preventing warping.
To prevent warping on cutting boards manufactured by
Richlite® material, simply turn the board over on a regularly
scheduled basis. Warping is caused by continued moisture and
temperature differences on the top and bottom of the boards.
By turning the board over, this will allow both sides of the
board to receive the same exposure.
There is a chance that larger sized boards may warp as a
characteristic of the material.
To Next Page
Loading...
