REFRIGERATED FOOD PREP
TEC_TM_090 | REV. C | EN 12/13/2022 Page 5 of 24
www.truemfg.com
Installation (cont.)
Uncrating
Tools Required
• Adjustable wrench
• Phillips screwdriver
• Level
The following procedure is recommended for uncrating the unit:
1. Remove the outer packaging (cardboard and bubbles or
styrofoam corners and clear plastic). See fig. 1. Inspect for
concealed damage. Again, immediately file a claim with
the freight carrier if there is damage.
NOTE: DO NOT remove the shipping bracket (glass swing
doors; fig. 2) until the unit is installed in its final location. Do
not discard; use the bracket/blocks when next moving the
cabinet.
2. With an adjustable wrench, remove all shipping bolts securing
the wood skid to the bottom of the cabinet. See fig. 3.
NOTE: Move the unit as close as possible to the final
location before removing the wooden skid. Some models
may require removing the front and/or rear grill to access
the shipping bolts.
3. If leveling legs or castors will not be used, remove the
cabinet from the wood skid and set the skid aside.
NOTE: DO NOT lift the cabinet by the countertops, doors,
drawers, or grills.
If leveling legs or castors will be used, rotate the cabinet on
the skid (see fig. 4) and see the installation instructions on
page 6.
NOTE: Remember to leave cabinet upright for 24 hours before
plugging into a power source. Keys for cabinet with door locks
are located in the warranty packet.
Fig. 3. Remove all shipping bolts.
Fig. 2. Do not remove shipping brackets until unit is in final location.
Fig. 1. Remove exterior packaging.
Fig. 4. Rotate cabinet on skid to install leveling legs or castors.
To Next Page
Loading...
