2-10 800TCU User’s Guide 800gench2.fm Rev. A
Installation and Operation
Table 2-2 I/O Commands
2.10 Command Descriptions
In the following command descriptions, the symbol <CR> indicates an ASCII carriage
return character and the symbol <LT> indicates the Line Terminator for RS-232 strings.
IEEE-488 transmissions will always terminate with a carriage return character.
RS-232 LINE TERMINATOR (LT)
RS-232 command only. The user may specify the character(s), if any, that are used to
terminate all transmissions from the 800 TCU. See table below for the line terminator
code description.
Example Read: LT<CR>
Example Response: O<CR>
No line terminator selected
Example Write: LT3<CR>
All outputs are ended with a line feed and a carriage
return
.
Name Commands
AUTO TIME OUTPUT AU (RS-232 only)
ERROR EB
FILTER POLARITY ENABLE FP
FORWARD FW
TIME FREEZE FZ
GENERATOR CODE SELECT GC
SYNC GEN INPUT CODE IC
LINE TERMINATOR LT (RS-232)
LEAP YEAR STATUS LY
MODE MD
PROPAGATION DELAY PD
REVERSE RV
START GENERATOR SG
STOP GENERATOR ST
TRANSLATE CODE SELECT TC
TIME TI
To Next Page
Loading...
Need help?
General