Truma Mover XT2 User Manual

2 EN
Safety instructions
Only competent and trained staff (experts) are permit-
ted to install and repair the Truma product and to carry
out the function test, at the same time observing the installa-
tion and operating instructions and the currently recognised
technical regulations. Experts are persons who, based on their
specialist instruction and training, their knowledge and experi-
ence with Truma products and the relevant standards, can
carry out the necessary work properly and identify potential
hazards.
– The Mover XT / XT2 may be operated only by persons of
legal age who have been made aware of the potential risks
when using the product and who are able to safely operate
the Mover together with the vehicle. Never allow children to
play with the Mover.
– Never use the Mover when under the influence of drugs,
alcohol or medication.
– Before using the manoeuvring assistant outdoors for the
first time, practice with it to familiarise yourself with the
functions of the remote control and the manoeuvring
assistant.
– Inspect the system for damage before use. The system
must not be used if it is damaged.
– Before each use of the manoeuvring assistant, check the
tyres and drive rollers and remove any sharp stones or
similar.
– The side slide switch on the remote control (ON / OFF) also
acts as an “Emergency Stop switch”. Switch the side slide
switch to “OFF” immediately in case of any noticeable
problems, e. g. uncontrolled behaviour of the manoeuvring
system.
– No person must be present in the caravan during operation.
If this is not observed, there is a risk of injury.
– There must be no persons (particularly children) within
the turning and movement range (manoeuvring range) of
the caravan. If this is not observed, there is a risk of injury.
– Ensure that there is sufficient visibility and space.
– When engaging and disengaging the MoverXT / XT2, make
sure that no hair, limbs, clothing or other parts on the body
can be caught by moving and / or rotating parts (e.g. drive
rollers). If this is not observed, there is a risk of injury.
– Always completely engage the drive rollers. If the drive
rollers are not completely engaged, the caravan cannot be
controlled. If this is not observed, there is a risk of injury
and property damage.
– During manoeuvring, the distance between the radio
remote control and the middle of the caravan must not
exceed 10 m.
– In case of a malfunction, engage the parking brake and
switch off the remote control.
– To avoid tilting the caravan, when manoeuvring on slopes
the drawbar should be pointed downwards (downhill). If
this is not observed, there is a risk of injury and property
damage.
– After manoeuvring, always first engage the parking brake,
disengage the drive rollers from the tyres and block
the wheels (especially on slopes). The MoverXT / XT2 is
notsuitable as a parking brake for the parked caravan.
– Always protect the radio remote control from unauthorised
access (paying particular attention to children).
Symbols used .....................................................................2
Warnings .............................................................................2
Safety instructions ............................................................2
General instructions ..........................................................3
Power supply ......................................................................3
Batteries ..............................................................................3
Charger .................................................................................. 3
Notes for handling batteries .................................................3
Battery care (including maintenance-free batteries) ............3
Function description .........................................................3
Intended use ..........................................................................4
Approval ................................................................................4
Operating instructions ......................................................4
Remote control ...................................................................... 4
Switching on the remote control ..........................................4
Remote control LED flashing code and acoustic signal .......5
Replacing remote control batteries .....................................5
Disposal ...............................................................................6
Uncoupling the towing vehicle .......................................6
Manoeuvring the caravan .................................................6
Coupling to a towing vehicle ................................................7
Maintenance .......................................................................7
Checks ................................................................................... 7
Emergency disengagement ..................................................7
Troubleshooting .................................................................7
Pairing the electronic control unit with the radio remote
control ...................................................................................8
Declaration of conformity ...............................................8
Technical Data ....................................................................8
Manufacturer's Warranty .................................................9
Symbols used
The appliance must be installed and repaired only by an
expert.
Symbol indicates possible hazards.
Note containing information and tips.
Warnings
The installer or vehicle owner must apply the yellow sticker
with the warning information, which is enclosed with the ap-
pliance, in a location in the vehicle where it is clearly visible
to all users (e.g. the wardrobe door). Missing stickers can be
requested from Truma.
Table of Contents

Truma Mover XT2 Specifications

General

Brand	Truma
Model	Mover XT2
Category	Automobile Accessories
Language	English