Truma Mover XT2 User Manual

8 EN
In the event of a system error (remote control LED 3 lights up
red), engage the parking brake, switch off the remote control
and switch it back on again after 2 seconds
Perform a reset with the parking brake applied, which takes
approx. 10 seconds (briefly disconnect battery or disconnect
and reconnect the safety plug)
If these actions do not remedy the problem, please contact
Truma Service.
Pairing the electronic control unit with the
radio remote control
The remote control and control unit are paired in the
factory.
If the control unit or remote control are replaced, they must
be paired again as described below.
Make sure that the drive rollers are not touching the wheel.
Check that the battery is properly connected and in good con-
dition, and that the control unit is being supplied with 12 V.
Make sure that the caravan connector is plugged into the
safety socket.
Read the following instructions beforehand, as you only
have limited time for pairing (approx. 10 seconds).
You will need a pen, a small screwdriver or similar to
press the reset button (k).
– Switch off the remote control.
– Switch on the control unit and wait for about 15 seconds
until the red LED (j) starts flashing slowly.
– Switch off the remote control.
– Press the reset button (k) on the control unit until the red
LED (j) flashes rapidly.
– Hold the engaging button (i) on the remote control de-
pressed and switch on the remote control with the slide
switch (a). Release the engaging button (i).
– Once the devices are paired, the red LED (j) on the control
unit and the green LED on the remote control (LED 4) re-
main permanently on.
If pairing was unsuccessful, the red LED (j) flashes and
you have to repeat the process.
i
a
j
k
LED 4
Figure 5
Declaration of conformity
Refer to the appendix
Technical Data
Operating voltage
12 V DC
Power consumption
on average approx. 28 A up to a maximum of 150 A
Quiescent current consumption
< 80 mA (with plug / adapter inserted)
< 150 µA (with plug / adapter removed)
Radio frequency
Class 2, 868 MHz
Speed
approx. 17 cm per second (depending on weight and slope)
Weight
approx. 28 kg
Fuse on plus wire
150 A
Area of application for MoverXT
single-axle caravans with a gross weight of up to 2300 kg
Area of application for MoverXT2
dual-axle caravans with a gross weight of up to 2400 kg

Truma Mover XT2 Specifications

General

Brand	Truma
Model	Mover XT2
Category	Automobile Accessories
Language	English