TSC DA210 Series - 4.4 Loading Media in Peel-off Mode

19
4.4 Loading Media in Peel-off Mode (Optional for DA220 series)
1. Please refer to section 3.2 to install the media.
Place the label leading edge onto the platen roller.
2. Close the top cover gently. Use software to make
calibration and set the post-print action to “PEEL”.
You may refer to Chapter 5 for configuring the
printer.
3. Move the media guides to fit the label width by
pushing the media guide adjustment button.
4. Close the peel-off cover and printer cover.
NOTE: Make sure the latches of peel-off cover
are correctly secured by the printer cover.