Why is the printing position of small label incorrect on my TSC Barcode Reader?
If the printing position of small labels is incorrect on your TSC Barcode Reader, recalibrate the media sensor sensitivity. Ensure the label size and gap size are set correctly. If using BarTender software, adjust the vertical offset in the driver settings.
What to do if the cutter is not working on my TSC Barcode Reader?
If your TSC Barcode Reader's cutter is not working, ensure the connector is correctly plugged in. Remove any label jams. If the issue persists, the cutter driver IC board might be damaged and need replacement.
Why is the RTC time incorrect when I reboot my TSC Barcode Reader?
If the RTC time is incorrect after rebooting your TSC Barcode Reader, check if there is a battery on the main board.
Why is there missing printing on the left or right side of label on my TSC Barcode Reader?
If your TSC Barcode Reader shows missing printing on the left or right side of the label, set the correct label size.
Why is there a gray line on the blank label from my TSC Barcode Reader?
To address a gray line on the blank label printed by your TSC Barcode Reader, clean the print head and the platen roller.
Step-by-step guide to physically setting up the printer.
Instructions for loading standard roll labels into the printer.
Steps to calibrate the gap or black mark sensor.
Procedure to reset printer settings to factory defaults.
Instructions on how to launch the TSC Diagnostic Utility software.
Overview of functions available within the Diagnostic Tool.
Lists common problems based on LED status and provides recovery procedures.
Details common printing issues and their potential solutions.
General| Model | DA320 Series |
|---|---|
| Connectivity | USB |
| Supported Barcode Types | 1D bar codes: Code 39, Code 128, etc. | 2D bar codes: PDF-417, DataMatrix, QR code, Aztec |
| Max. Print Speed | Not applicable |
| Max. Print Width | Not applicable |
| Max. Print Length | Not applicable |
| Humidity | 5% to 85% (non-condensing) |
To Next Page
