What to do if my TSC Barcode Reader says 'No Paper'?
If your TSC Barcode Reader shows 'No Paper', it might be due to an empty label roll. Replace it with a new one. If that's not the issue, the label roll might be installed incorrectly. Refer to the user’s manual to reinstall the label roll correctly. Also, the gap/black mark sensor may not be calibrated; try calibrating it.
What to do when my TSC MB240 says 'No Ribbon'?
If your TSC printer indicates 'No Ribbon': * Supply a new ribbon roll. * Refer to the user’s manual for instructions on reinstalling the ribbon.
How to improve print quality on a TSC printer?
If you're experiencing poor print quality on your TSC printer, consider these solutions: * Reload the supply. * Clean the print head and platen roller. * Adjust the print density and print speed. * Run a printer self-test and check the print head test pattern for missing dots. * Change to a proper ribbon or label media. * Adjust the printhead pressure adjustment knob. * Ensure the release lever properly latches the printhead.
General| Print Method | Thermal Transfer/Direct Thermal |
|---|---|
| Resolution | 203 dpi |
| Processor | 32-bit RISC CPU |
| Operating Humidity | 25-85% non-condensing |
| Connectivity | USB 2.0, RS-232 |
| Media Sensor | Reflective, Transmissive |
| Media Type | Continuous, Die-cut, Black mark, Fan-fold, Notched |
| Media Width | 25.4 mm |
| Media Thickness | 0.06 mm |
| Media Core Diameter | 25.4 mm (1") |
| Media Max Roll Diameter | 127 mm (5") |
| Ribbon Width | 110 mm |
| Ribbon Length | 300 m |
| Ribbon Core Diameter | 25.4 mm (1 inch) |
| Power | 100 - 240 VAC, 50/60 Hz |
| Maximum Print Length | 9999 mm |
| Label Width | 25.4 mm |
| Label Thickness | 0.06 mm |
| Power Supply | 100-240V AC, 50-60Hz |
| Operating Temperature | 5°C - 40°C |
| Storage Temperature | -20°C - 60°C |
| Certifications | CE |
To Next Page
