TSC MX641P Series

- 41 -
7.3 Setting
Tap the “Command Set” item on LCD to switch the TSPL and ZPL2. Or select the “Command
Set” item by navigational key and press right soft key to switch the TSPL and ZPL2.
7.3.1 TSPL
This “TSPL” category can set up the printer settings for TSPL.
Item
Description
Default
Speed
Use this item to setup print speed. Available setting range is
2~14 for 203dpi, 2~12 for 300dpi and 1~6 for 600dpi.
203
dpi: 6
300
dpi: 4
600
dpi: 3
Slew Speed
Use this item to setup feed speed. Setting value is up to 8
ips.
203
dpi: 6 ips
Setting TSPL
Speed
Slew speed
Back speed
Density
Direction
Print mode
Batch Mode
None
Cutter Batch
Cutter Mode
Rewinder Mode
Peeler Mode
Applicator Mode
Offset
Shift X
Shift Y
Reference X
Reference Y
Code Page
Country