TSC PEX-1121 Series - Loading Media in Peel-Off Mode

- 22 -
fff
3.3.2 Loading Media in Peel-off Mode
1. Open the print engine cover.
2. Please refer to section 3.3.1 step 3~8 for loading media.
Note:
* Please calibrate the gap/black mark sensor before loading media in peel-off mode to
avoid paper jam.
* There are no peel-off sensor and liner rewind spindle for standard model.
3. Open print head release lever and label guide bar release lever to pull approximately 650mm of
label through the front of the print engine.
4. Remove several labels to leave liner.
Left-hand model
Right –hand model
5. Open the peel-off roller release lever.
Left-hand model
Right –hand model