TSC PEX-1121 Series - Zpl2

- 40 -
7.3.2 ZPL2
This “ZPL2” category can set up the print engine settings for ZPL2.
Item
Description
Default
Density
Use this item to setup printing darkness. The available
setting range is from 0 to 30. You may need to adjust
your density based on selected media.
16
Print Speed
Use this item to setup print speed. Available setting
range is 2~18 for 203dpi, 2~14 for 300dpi and 1.5 ~6 for
600dpi.
203 dpi: 6 ips
300 dpi: 4 ips
600 dpi: 3 ips
Menu ZPL2
Darkness
Print Speed
Slew Speed
BackFeed Speed
Tear Off
Print Mode
Tear Off
Applicator
Stream
Rewind
Print Width
List Fonts
List Images
List Formats
List Setup
Control Prefix
Format Prefix
Delimiter Char
Media Power Up
Feed
Calibration
Length
No Motion
Head Close
Feed
Calibration
Length
No Motion
Label Top
Left Position
Reprint Mode
Enabled
Disabled
Format Convert