TSC PRINTRONIX TX210 Series User Manual

49
printer is 9600,n,8,1.
* If using the Ethernet cable,
- Check if the Ethernet RJ-45 connector green LED is lit on.
- Check if the Ethernet RJ-45 connector amber LED is
blinking.
- Check if the printer gets the IP address when using DHCP
mode.
- Check if the IP address is correct when using the static IP
address.
- Wait a few seconds let the printer get the communication
with the server then check the IP address setting again.
* Please reset the wireless device setting.
* Select the correct printer port in the driver.
* Print head’s harness connector is not well connected with
printheat. Turn off the printer and plug the connector again.
* Check your program if there is a command PRINT at the end
of the file and there must have CRLF at the end of each
command line.
No print on the label
* Label or ribbon is loaded not correctly.
* Use wrong type paper or ribbon
* Follow the instructions in loading the media and ribbon.
* Ribbon and media are not compatible.
* Verify the ribbon-inked side.
* The print density setting is incorrect.
* Clean the print head.
Poor Print Quality
* Ribbon and media is loaded incorrectly
* Dust or adhesive accumulation on the print
head.
* Print density is not set properly.
* Print head element is damaged.
* Ribbon and media are incompatible.
* The print head pressure is not set properly.
* Reload the supply.
* Clean the print head.
* Clean the platen roller.
* Adjust the print density and print speed.
* Run printer self-test and check the print head test pattern if
there is dot missing in the pattern.
* Change proper ribbon or proper label media.
* The release lever does not latch the print head properly.
Take Label
* Peel function is enabled.
* If the peeler module is installed, please remove the label.
* If there is no peeler module in front of the printer, please
switch off the printer and install it.
* Check if the connector is plugging correctly.
Cutter is not working
* The connector is loose.
* Cutter jam.
* Cutter PCB is damaged.
* Plug in the connect cable correctly.
* Remove the label.
* Make sure the thickness of label is less than 0.19 mm.

TSC PRINTRONIX TX210 Series Specifications

General

Brand	TSC
Model	PRINTRONIX TX210 Series
Category	Barcode Reader
Language	English