TSC PRINTRONIX TX210 Series - Loading the Media in Cutter Mode (Option)

16
3.4 Loading the Media in Cutter Mode (Option)
1. Please refer to section
3.3 to install the media .
2. Lead the paper through the
cutter paper opening.
3. Move the media guides
to fit the label width by
pushing the media
guide adjustment
button.
4. Open the peel-off cover.
Feed the liner into peel-off
cover slot.
5. Use software to set the
media sensor type, calibrate
the selected sensor and set
the post-print action to
“CUTTER”.(Please refer to
chapter 5)