Why is my TSC TC300 missing printing on the sides of the label?
If your TSC Barcode Reader is missing printing on the left or right side of the label, the label size setup might be incorrect. Set the correct label size in your printer settings.
How to correct the printing position of small labels on my TSC TC300 Barcode Reader?
If the printing position of small labels is incorrect on your TSC Barcode Reader, recalibrate the media sensor sensitivity. Ensure the label size and gap size are correctly set. Fine-tune the Shift Y parameter using DiagTool. If using BarTender software, adjust the vertical offset in the driver settings.
What to do if my TSC TC300 is unable to use the SD card?
If your TSC Barcode Reader is unable to use the SD card, ensure that the SD card is not damaged and use a supported capacity SD card. Also, try reinserting the SD card to ensure it is correctly placed.
Why is the RTC time incorrect when I reboot my TSC Barcode Reader?
Check if there is a battery on the main board.
General| Brand | TSC |
|---|---|
| Model | TC300 Series |
| Category | Barcode Reader |
| Language | English |
Details the front view of the TC210 and TC200 series printers, including component labels.
Illustrates and labels internal components of the printer for maintenance.
Shows and labels the rear interfaces of the TC210 and TC200 series printers.
Lists and identifies connectors on the main board for TC200/TC300 series.
Details pin configurations for RS-232C, USB, and Centronics interfaces.
Step-by-step guide to replacing the LED or LCD module.
Detailed instructions for replacing the main board of the printer.
Guide for replacing the head open sensor component.
Steps to remove and replace the platen roller assembly.
Instructions for replacing the print head assembly.
Guide on how to replace the stepping motor.
Steps to replace the black-mark sensor module.
Instructions for replacing the gap sensor (transmitter).
Detailed steps to remove and replace the media holder.
Guide for installing the optional peel-off module.
Steps for installing the optional cutter module.
To Next Page
