32
6. Maintenance
This session presents the clean tools and methods to maintain your printer.
1. Please use one of following material to clean the printer.
Cotton swab (Head cleaner pen)
Lint-free cloth
Vacuum / Blower brush
100% ethanol
2. The cleaning process is described as following:
Printer Part Method Interval
1. Always turn off the printer before cleaning
the print head.
2.
llow the print head to cool for a minimum
of one minute.
3. Use a cotton swab and 100% ethanol to
clean the print head surface.
Clean the print head when changing a
new label roll
Print Head
Platen Roller
1. Turn the power off.
2. Rotate the platen roller and wipe it
thoroughly with 100% ethanol and a
cotton swab, or lint-free cloth.
Clean the platen roller when changing
a new label roll
Tear Bar/Peel Bar
Use the lint-free cloth with 100% ethanol to
wipe it.
As needed
Sensor
Compressed air or vacuum Monthly
Exterior
Wipe it with water-dampened cloth As needed
Interior
Brush or vacuum As needed
Note:
z Do not touch printer head by hand. If you touch it careless, please use ethanol to clean it.
z Please use 100% Ethenol. DO NOT use medical alcohol, which may damage the printer head.
To Next Page
Loading...
