TSC TDP-245 Plus

16
7. Plug in the Cutter Driver IC at U14(TDP-245) / U30(TDP-245
Plus/TDP-247/TDP-345) socket on the main board.
TDP-245 Model
TDP-245 Plus/TDP-247/TDP-345 Model
Note:
For Non-RoHS PCB, use cutter driver IC A3952SB
For RoHS PCB, use cutter driver IC A3953SB
8. Hold the lower cover and lift up the lower inner cover.
9. Arrange the cutter module harness through the bezel.
10. Connect the cutter module harness to the 4-pin socket on printer PCB.
11. Reassemble lower inner cover back to the lower cover.
12. Install the cutter module into the niche of the printer.
Bezel
Socket
Cutter Driver IC