24
4.1.3 Printer Initialization
Printer initialization clears all downloaded files resident in flash memory, and sets
printer parameters to default values.
Parameter Default Value
MILEAGE Automatic
CHECK SUM Automatic
SERIAL PORT 9600,N,8,1
CODE PAGE 437 (8 bit), USA (7 bit)
COUNTRY CODE 001
SPEED 2.0”/sec
DENSITY 08
SIZE 4”, 2.5"
GAP (BLINE) 0.12, 0
TRANSPARANCY Will be reset. Need to re-
calibrate the gap sensor
Please follow the steps below to initialize the printer:
1. Turn off the printer power.
2. Hold down the PAUSE and FEED buttons and turn on the printer power.
3. Do not release the buttons until the three LEDs flash in turn.
Note 1: Printing method (thermal transfer or thermal direct printing ) will be
set automatically at the activation of printer power.
Note 2: When printer initialization is done, please calibrate the gap sensor
again.
Note 3: Download files will be deleted after printer initialization.
To Next Page
Loading...
