EN
UNI 30 E 17261 - 561.228 2 - GENERAL INFORMATION
2
- Pag. 2/3
THIS MANUAL IS PROPERTY OF - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
Cap.
ATTENTION: this symbol indicates safety regulations regarding the operator.
PRECAUTION: this symbol indicates the possibility of causing damage to the machine and/or its parts.
DANGER: this symbol indicates the presence of electrical energy.
IMPORTANT NOTE: this symbol supplies useful information.
2.5 MACHINE OFF
Before performing any type of maintenance and/or adjustment on the machine it is mandatory to isolate all power supply
sources. Make sure that the machine is effectively off and cannot start-up unexpectedly. Take the by-pass lever to the vertical
position (FIG.01-REF.1), make sure that the manometer indicates a pressure of "0" zero bar (FIG.01-REF.2), take the master
switch to the "0" position (FIG.02-REF.1) and ensure that the electric power supply cable is disconnected from the mains
socket and positioned near to the machine).
2
1
1
2
2
FIG.01 FIG.02
To Next Page
Loading...
