turck PS310 Series - Setting Via Touchpads; Unlocking the Touchpads; Locking the Touchpads; Setting Parameter Values Via Touchpads

Setting
Setting via touchpads
22
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
Fig.19: Password setting
9.1 Setting via touchpads
Use the [MODE], [SET] or [ENTER] touchpads to set the parameters.
9.1.1 Unlocking the touchpads
 Touch [ENTER] for 3 s until all green bars are flashing on the display.
 Swipe the [MODE], [ENTER], [SET] touchpads in that order in succession: Two red flashing
bars appear on the display when each touchpad is touched.
 Swipe the next touchpad once the two red bars turn green.
 Release the touchpads when six green bars are lit on the display.
a LED LOC flashes first and then goes out.
9.1.2 Locking the touchpads
 Touch and hold down [MODE] and [SET] for 3 s.
a LOC flashes first and then is permanently lit yellow.
The sensor is automatically locked if the touchpads of the sensor are not actuated for 1 min.
9.1.3 Setting parameter values via touchpads
 If the display shows a red running light when [MODE] and [SET] are touched, unlock the
device.
 Touch [MODE] or [SET] until the required parameter appears in the display.
 Touch [ENTER] to select the parameter.
 Changing the displayed value: Touch [SET] for 3 s until the display is no longer flashing.
 Increase or decrease the value gradually via [MODE] or [SET]. Certain values can also be
continuously changed by holding down [MODE] or [SET].
 Touch [ENTER] to save the modified value. The saved value flashes twice and all unit LEDs
are lit once.
 Protect the sensor with a password: Select PASS in the EF menu. Change values via [SET].
Use [MODE] to navigate between the four digits of the password.