V01.00 | 2020/01
9
4 Product Description
The pressure sensors of the PS+ series are contained in a metal housing with a display and are
available with different process connections. The housing can also be aligned and fastened as
required after mounting. All devices are provided with a metal-bodied M12 connector for con-
necting the sensor cable.
The devices can be set via the touchpads, FDT/DTM or IO-Link. The measured pressure can be
displayed in bar, psi, kPa, MPa and in ten other units of pressure (Ud1...Ud10).
Devices with the following output functions are available for selection:
n PS…2UPN8…: Two switching outputs (PNP/NPN)
n PS…LI2UPN8…: One switching output (PNP/NPN) as well as one switching output (PNP/
NPN) or one analog output (adjustable as current or voltage output)
4.1 Device overview
24
91.5 [3.60]
ø 38 [1.50]
Electrical Connection
Process Connection
L
55.1 [2.17]
12.2 [0.48]
Fig.1: Dimensions in mm [inch]
4.2 Properties and features
n Pressure monitoring of fluid group 2
n IO-Link 1.1
n Automatic signal detection
n Up to 7-fold overpressure resistance
n Protection types IP6K6K, IP6K7, IP6K9K
n 180° invertible multi-color display
n Rotatable sensor body
n Stainless steel housing 1.4305 (AISI 303) or 1.4404 (316 L)
n Electronic output:
– 1 PNP/NPN output + 1 analog or PNP/NPN output
– 2 PNP/NPN outputs
4.3 Operating and display functions
The front of the device is provided with three touchpads [ENTER], [MODE] and [SET], a 4-digit
12-segment multicolor display and status LEDs. This enables the user to set all essential func-
tions and properties directly on the device and read the actual process values and taught
switch points.
To Next Page
Loading...
