For Your Safety
General safety instructions
8
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
3 For Your Safety
The product is designed according to state-of-the-art technology. However, residual risks still
exist. Observe the following warnings and safety notices to prevent damage to persons and
property. Turck accepts no liability for damage caused by failure to observe these warning and
safety notices.
3.1 Intended use
The devices are intended for use in the industrial sector.
The pressure sensors of the PS series monitor media belonging to fluid group 2 and show the
measured values in a display. The sensors are vacuum-tight.
The devices may only be used as described in these instructions. Any other use is not in accord-
ance with the intended use. Turck accepts no liability for any resulting damage.
3.2 Obvious misuse
n The devices are not safety components and must not be used for personal or property pro-
tection.
3.3 General safety instructions
n The device only meets the EMC requirements for industrial areas and is not suitable for use
in residential areas.
n The device may only be assembled, installed, operated, parameterized and maintained by
professionally-trained personnel.
n The device may only be used in accordance with applicable national and international regu-
lations, standards and laws.
n The maximum permissible overpressure must not be exceeded.
To Next Page
Loading...
