12
T650/T950H ASSEMBLY INSTRUCTIONS — STAGE THREE
The numbers in parentheses correspond with the drawing on the facing page.
13. INSTALL DRIVE SHAFT ASSEMBLY – PRE-LUBE BEARING
14. INSTALL END COVER
14.1. Install O-ring in end plate – use grease to retain.
14.2. Prep end cover (17).
14.3. Install wave washer (16).
14.4. Oil bearing surface.
14.5. Install alignment bolts.
14.6. Align and install cover over alignment bolts.
14.7. Install three cap screws (18) and draw cover into position over bearing.
Note: There should only be a light fit to the bearing
14.8. Loosen cap screws.
14.9. Install dowels (17) into end plate and cover.
14.10. Install and tighten cap screws on cover – use Loctite.
14.11. Grease drive shaft seal (19).
14.12. Install seal into cover – use Loctite on outer perimeter.
15. INSTALL OIL PUMP ASSEMBLY
15.1. Install oil pump spring and spacer.
15.2. Position oil pump (9) with pin (8) in small radius area.
15.3. Install dowels (2).
15.4. Grease O-rings (3) (4) and install into pump plate.
15.5. Install pump plate (5) and 6 bolts (7) – oil pump plate can only go on one way - use Loctite.
16. INSTALL GEAR END COVER (FROM STAGE TWO DRAWINGS (26(27)).
17. INSTALL INLET PORT.
18. INSTALL EXTERNAL OIL LINES AND FITTINGS.
19. INSTALL DISCHARGE MANIFOLD.
To Next Page
Loading...
