2
1. Do not operate before reading the enclosed instruction manual.
2. Use adequate protection, warning and safety equipment necessary to protect against hazards involved in installation and
operation of this equipment.
SAFETY INSTRUCTIONS
SAFETY WARNING
• Keep hands and clothing away from rotating machinery, inlet and discharge openings.
• Blower and drive mounting bolts must be secured.
• Drive belts and coupling guards must be in place.
• Noise level may require ear protection.
• Blower heat can cause burns if touched.
NOTICE
The above safety instruction tags were attached to your unit prior to shipment. Do not remove, paint over or obscure in any manner. Failure
to heed these warnings could result in serious bodily injury to the personnel operating and maintaining this equipment.
SAFETY PRECAUTIONS
FOR EQUIPMENT COVERED SPECIFICALLY OR INDIRECTLY IN THIS INSTRUCTION BOOK, IT IS IMPORTANT
THAT ALL PERSONNEL OBSERVE SAFETY PRECAUTIONS TO MINIMIZE THE CHANCES OF INJURY. AMONG MANY
CONSIDERATIONS, THE FOLLOWING SHOULD PARTICULARLY BE NOTED:
• Rotating shafts can be dangerous. You can snag clothes, skin, hair, hands, etc. This can cause serious injury or death.
• Do not work under the vehicle when the engine is running.
• Do not work on a shaft (with or without a guard) when the engine is running.
• Do not engage or disengage driven equipment by hand from under the vehicle when the engine is running.
• In order to avoid becoming entangled, install the power take off and/or shaft behind the frame rail, tanks, battery box, etc.
• If power take off and/or shaft are still exposed after installation, install a guard.
• Install a support strap when servicing a drive shaft to prevent personal injury.
A SERIOUS OR FATAL INJURY CAN OCCUR . . .
• if you lack proper training
• if you fail to follow proper procedures
• if you do not use proper tools and safety equipment
• if you assemble drive line components improperly
• if you use incompatible drive line components
• if you use worn-out or damaged drive line components
• if you use drive line components in a non-approved application.
THIS MANUAL CONTAINS SAFETY INSTRUCTIONS. READ, UNDERSTAND AND FOLLOW THIS MANUAL.
• Get proper training
• Learn and follow safe operating procedures
• Use proper tools and safety equipment
• Use proper components in good condition
WARNING
Keep body and
clothing away from
machine openings.
CAUTION
Do not
operate without
guards in place.
CAUTION
Do not
touch hot
surfaces.
WARNING
Keep body
and clothing away
from drive shaft.
To Next Page
Loading...
