How to fix a Tuttnauer 2540E Laboratory Equipment chamber that is not filling?
If the chamber of your Tuttnauer Laboratory Equipment is not filling, check the water level in the reservoir. Also, inspect the bottom of the reservoir for any obstruction blocking the pickup tube. Clean the water sensor and try filling the machine manually using the Manual Inlet key.
Why is the drying cycle taking so long in my Tuttnauer 2540E?
If the drying cycle in your Tuttnauer Laboratory Equipment is taking too long, the autoclave may be overloaded. Also, consider replacing the HEPA filter.
Why does the exhaust stage take so long when running a cycle on my Tuttnauer Laboratory Equipment?
If you are running a ‘glassware’ program on your Tuttnauer Laboratory Equipment, this is normal. The slow exhaust will take between 15 and 20 minutes.
Why is there a loud noise coming from the reservoir of my Tuttnauer 2540E?
If there is a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature might be set too high. The maximum setting is 274ºF (134ºC).
How do I fix a Tuttnauer Laboratory Equipment printer that doesn't print?
If the printer of your Tuttnauer Laboratory Equipment does not print, ensure the paper is inserted in the printer. If the printer prints a test printout, the printer is O.K. and there is a problem with the electronics. Contact your dealer to solve the problem. If the printer does not print the test printout, there is a problem with the printer. Contact your dealer to solve the problem.
Inspecting the autoclave upon delivery for any signs of damage.
Provides detailed electrical specifications, including amp, watt, and fuse ratings.
Specifies the required physical and chemical characteristics of water for the autoclave.
Details the functions of each key on the control panel and program selection.
Explains error messages, warnings, and associated safety measures.
Covers electrical connection requirements, safety relays, and grounding.
Guidelines for loading, unloading, and safety during operation.
Instructions on how to properly fill the water reservoir with distilled water.
Steps for cleaning, rinsing, and preparing instruments before sterilization.
Steps for filling reservoir, connecting power, and selecting programs.
Instructions for loading material, closing the door, and starting the autoclave.
Outlines daily, weekly, and periodic maintenance tasks for the autoclave.
Procedure for cleaning the air jet to prevent sterilization failures.
Procedure for cleaning and descaling the autoclave using Chamber Brite.
Solutions for issues where the machine is unresponsive or displays 'Low Heat'.
Troubleshooting steps for 'Low Water' and 'Low Pres' error messages.
Solutions for 'Low Temp' and 'High Pres' error messages.
General| Model | 2540E |
|---|---|
| Number of Trays | 2 |
| Type | Autoclave |
| Power Supply | 230V, 50/60Hz |
| Power | 1700W |
| Current | 7.4A |
| Sterilization Pressure Range | 15-30 psi |
| Standard Cassettes Capacity | 2 |
| Standard Accessories | 1 tray |
| Cycle Time | Approximately 30 minutes |
| Heating Element | 1.5 kW |
| Power Consumption | 1.5 kW |
| Sterilization Temperature Range | 121°C - 134°C (250°F - 273°F) |
To Next Page
