Why are wraps burned after using Tuttnauer 2540EA?
To address wraps coming out burned from your Tuttnauer Laboratory Equipment, check if the water sensor is dirty. Also, verify that the wall outlet voltage is not too high and ensure items are not touching the chamber walls or bottom. Load the autoclave according to the instructions.
What to do when my Tuttnauer 2540EA Laboratory Equipment displays ‘High Temp’?
If your Tuttnauer Laboratory Equipment displays ‘High Temp’, clean the air jet and check for proper voltage at the wall outlet.
What does ‘Low Heat’ mean on my Tuttnauer 2540EA?
If the message ‘Low Heat’ is displayed during heat up on your Tuttnauer Laboratory Equipment, it indicates a bad temperature sensor. If heating elements are remaining on instead of cycling on and off, call for a technician.
How to clean a very dirty chamber in my Tuttnauer 2540EA?
If the chamber of your Tuttnauer Laboratory Equipment is very dirty, use Chamber Brite ™ to clean the autoclave; very dirty machines may require two cleanings.
Why are instruments rusting in my Tuttnauer 2540EA Laboratory Equipment?
If instruments are rusting after sterilization in your Tuttnauer Laboratory Equipment, first determine if it's true rust by using a pencil eraser to remove the brown spot. If there is no pitting, the instrument is just dirty. Use distilled water for sterilizing and ensure dissimilar metals are not in contact with each other.
Why does Tuttnauer 2540EA Laboratory Equipment printer feed paper constantly?
If the printer on your Tuttnauer Laboratory Equipment gives paper feeds all the time when the machine is switched on, make sure the ‘feed button’ on the printer is not stuck.
What to do if the keyboard of my Tuttnauer Laboratory Equipment does not respond?
If the keyboard of your Tuttnauer Laboratory Equipment does not respond, press the STOP key for 2 seconds to abort any program that may still be running.
How to troubleshoot a Tuttnauer 2540EA system that shows no response when turned on?
If your Tuttnauer Laboratory Equipment does not respond when you turn it on, try the following: First, check and fix all connections. If the issue persists, replace any faulty cables, connectors, or the power switch.
Why is my Tuttnauer 2540EA making a loud noise?
If you hear a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature may be set too high. The maximum setting is 274ºF (134ºC).
How to clean a very dirty Tuttnauer Laboratory Equipment chamber?
To clean a very dirty chamber in your Tuttnauer Laboratory Equipment, use Chamber Brite ™. Very dirty machines may require two cleanings.
Inspect the autoclave for damage upon arrival and verify packing integrity.
Provides detailed electrical specifications, including voltage, amperage, and fuse ratings.
Presents overall dimensions, weight, and other physical characteristics of the autoclave models.
Lists chamber dimensions, water reservoir capacity, tray sizes, and shipping details.
Detailed explanation of program keys and other control buttons on the autoclave interface.
Explains common messages, error codes, and safety measures displayed by the autoclave.
Details the settings and sequence for sterilizing unwrapped instruments.
Outlines the parameters for sterilizing wrapped instruments and porous materials.
Specifies the cycle for sterilizing glassware with slow exhaust and no drying.
Describes the program used for an additional drying cycle for specific items.
Guides on proper electrical connection, safety, and compliance with regulations.
Procedures for setting and checking the automatic water filling system.
Covers daily, weekly, and periodic maintenance tasks for optimal device performance.
General| Type | Automatic Autoclave |
|---|---|
| Voltage | 120V or 230V |
| Frequency | 50/60 Hz |
| Power | 1400W |
| Door Type | Manual |
| Number of Trays | 2 |
| Safety Features | automatic shut off at the end of both sterilization and drying cycles, Overheat cut-off, automatic shut off at the end of both sterilization and drying cycles, insufficient water level sensor |
To Next Page
