How to fix a Tuttnauer 2540EA chamber that is not filling?
If the chamber of your Tuttnauer Laboratory Equipment is not filling, check the water level in the reservoir. Also, inspect the bottom of the reservoir for any obstruction blocking the pickup tube. Clean the water sensor and try filling the machine manually using the Manual Inlet key.
Why is the drying cycle taking so long in my Tuttnauer Laboratory Equipment?
If the drying cycle in your Tuttnauer Laboratory Equipment is taking too long, the autoclave may be overloaded. Also, consider replacing the HEPA filter.
Why does the exhaust stage take so long when running a cycle on my Tuttnauer 2540EA Laboratory Equipment?
If you are running a ‘glassware’ program on your Tuttnauer Laboratory Equipment, this is normal. The slow exhaust will take between 15 and 20 minutes.
Why is there a loud noise coming from the reservoir of my Tuttnauer 2540EA?
If there is a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature might be set too high. The maximum setting is 274ºF (134ºC).
How do I fix a Tuttnauer 2540EA printer that doesn't print?
If the printer of your Tuttnauer Laboratory Equipment does not print, ensure the paper is inserted in the printer. If the printer prints a test printout, the printer is O.K. and there is a problem with the electronics. Contact your dealer to solve the problem. If the printer does not print the test printout, there is a problem with the printer. Contact your dealer to solve the problem.
Inspect the autoclave for damage upon arrival and verify packing integrity.
Provides detailed electrical specifications, including voltage, amperage, and fuse ratings.
Presents overall dimensions, weight, and other physical characteristics of the autoclave models.
Lists chamber dimensions, water reservoir capacity, tray sizes, and shipping details.
Detailed explanation of program keys and other control buttons on the autoclave interface.
Explains common messages, error codes, and safety measures displayed by the autoclave.
Details the settings and sequence for sterilizing unwrapped instruments.
Outlines the parameters for sterilizing wrapped instruments and porous materials.
Specifies the cycle for sterilizing glassware with slow exhaust and no drying.
Describes the program used for an additional drying cycle for specific items.
Guides on proper electrical connection, safety, and compliance with regulations.
Procedures for setting and checking the automatic water filling system.
Covers daily, weekly, and periodic maintenance tasks for optimal device performance.
General| Type | Automatic Autoclave |
|---|---|
| Voltage | 120V or 230V |
| Frequency | 50/60 Hz |
| Power | 1400W |
| Door Type | Manual |
| Number of Trays | 2 |
| Safety Features | automatic shut off at the end of both sterilization and drying cycles, Overheat cut-off, automatic shut off at the end of both sterilization and drying cycles, insufficient water level sensor |
To Next Page
