Why are wraps burned after using Tuttnauer 2540EKA Laboratory Equipment?
To address wraps coming out burned from your Tuttnauer Laboratory Equipment, check if the water sensor is dirty. Also, verify that the wall outlet voltage is not too high and ensure items are not touching the chamber walls or bottom. Load the autoclave according to the instructions.
What to do when my Tuttnauer 2540EKA Laboratory Equipment displays ‘High Temp’?
If your Tuttnauer Laboratory Equipment displays ‘High Temp’, clean the air jet and check for proper voltage at the wall outlet.
What does ‘Low Heat’ mean on my Tuttnauer 2540EKA Laboratory Equipment?
If the message ‘Low Heat’ is displayed during heat up on your Tuttnauer Laboratory Equipment, it indicates a bad temperature sensor. If heating elements are remaining on instead of cycling on and off, call for a technician.
How to clean a very dirty chamber in my Tuttnauer Laboratory Equipment?
If the chamber of your Tuttnauer Laboratory Equipment is very dirty, use Chamber Brite ™ to clean the autoclave; very dirty machines may require two cleanings.
Why are instruments rusting in my Tuttnauer 2540EKA?
If instruments are rusting after sterilization in your Tuttnauer Laboratory Equipment, first determine if it's true rust by using a pencil eraser to remove the brown spot. If there is no pitting, the instrument is just dirty. Use distilled water for sterilizing and ensure dissimilar metals are not in contact with each other.
Why does Tuttnauer 2540EKA printer feed paper constantly?
If the printer on your Tuttnauer Laboratory Equipment gives paper feeds all the time when the machine is switched on, make sure the ‘feed button’ on the printer is not stuck.
What to do if the keyboard of my Tuttnauer 2540EKA Laboratory Equipment does not respond?
If the keyboard of your Tuttnauer Laboratory Equipment does not respond, press the STOP key for 2 seconds to abort any program that may still be running.
How to troubleshoot a Tuttnauer Laboratory Equipment system that shows no response when turned on?
If your Tuttnauer Laboratory Equipment does not respond when you turn it on, try the following: First, check and fix all connections. If the issue persists, replace any faulty cables, connectors, or the power switch.
Why is my Tuttnauer 2540EKA making a loud noise?
If you hear a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature may be set too high. The maximum setting is 274ºF (134ºC).
How to clean a very dirty Tuttnauer Laboratory Equipment chamber?
To clean a very dirty chamber in your Tuttnauer Laboratory Equipment, use Chamber Brite ™. Very dirty machines may require two cleanings.
Specifies acceptable physical and chemical characteristics for water.
Step-by-step guide for replacing the HEPA air filter.
Procedure for emptying and cleaning the water reservoir.
Instructions for cleaning the air jet to ensure proper operation.
How to remove and install a new door gasket.
Procedure for monthly checking of the safety valve.
Guide to replacing blown fuses for water and air pumps.
Steps for cleaning the water outlet strainer.
Procedure for using Chamber Brite for cleaning and descaling.
Instructions for cleaning the water sensor for accurate level reporting.
Solutions for when the autoclave fails to power on or operate.
Troubleshooting steps for the 'Low Heat' display.
Solutions for the 'Low Water' indicator.
Troubleshooting steps for the 'Low Pres' display.
Solutions for the 'Low Temp' indicator and potential causes.
Troubleshooting for 'High Temp' messages and sensor issues.
Solutions for the 'High Pres' display and potential causes.
Steps to resolve a clogged drain valve or line, and chamber fill issues.
General| Brand | Tuttnauer |
|---|---|
| Model | 2540EKA |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
