Why is my Tuttnauer Laboratory Equipment leaking at the door?
If your Tuttnauer Laboratory Equipment is leaking at the door, ensure the door is tightened enough and the door gasket is sealing the chamber. If necessary, replace the door gasket.
Why are wraps burned after using Tuttnauer 2540EKA Laboratory Equipment?
To address wraps coming out burned from your Tuttnauer Laboratory Equipment, check if the water sensor is dirty. Also, verify that the wall outlet voltage is not too high and ensure items are not touching the chamber walls or bottom. Load the autoclave according to the instructions.
How to clean a very dirty Tuttnauer Laboratory Equipment chamber?
To clean a very dirty chamber in your Tuttnauer Laboratory Equipment, use Chamber Brite ™. Very dirty machines may require two cleanings.
Why does Tuttnauer 2540EKA Laboratory Equipment take so long to heat up?
If your Tuttnauer Laboratory Equipment takes too long to heat up, clean the air jet and check for proper voltage at the wall outlet.
What to do if spore tests fail in Tuttnauer 2540EKA Laboratory Equipment?
If spore tests are failing or indicator strips are not turning in your Tuttnauer Laboratory Equipment, clean the air jet. Also, make sure the sterilization time and temperature are set correctly, and ensure the autoclave is not too heavily loaded.
Why does Tuttnauer 2540EKA printer feed paper constantly?
If the printer on your Tuttnauer Laboratory Equipment gives paper feeds all the time when the machine is switched on, make sure the ‘feed button’ on the printer is not stuck.
How to troubleshoot Tuttnauer 2540EKA Laboratory Equipment machine not responding?
If your Tuttnauer Laboratory Equipment machine isn't responding, verify that the main switch is in the ‘On’ position, the power cord is properly connected to both the machine and the mains, and the circuit breaker hasn't tripped. Also, check the reset button on the cut-out thermostat.
What to do if Tuttnauer 2540EKA process fails during heating stage with a HIGH TEMP message?
If your Tuttnauer Laboratory Equipment process fails while initiating the heating stage and displays a HIGH TEMP message, try changing the setting of the thermostat.
How to clean a very dirty chamber in my Tuttnauer Laboratory Equipment?
If the chamber of your Tuttnauer Laboratory Equipment is very dirty, use Chamber Brite ™ to clean the autoclave; very dirty machines may require two cleanings.
What does ‘Low Heat’ mean on my Tuttnauer 2540EKA Laboratory Equipment?
If the message ‘Low Heat’ is displayed during heat up on your Tuttnauer Laboratory Equipment, it indicates a bad temperature sensor. If heating elements are remaining on instead of cycling on and off, call for a technician.
Specifies acceptable physical and chemical characteristics for water.
Step-by-step guide for replacing the HEPA air filter.
Procedure for emptying and cleaning the water reservoir.
Instructions for cleaning the air jet to ensure proper operation.
How to remove and install a new door gasket.
Procedure for monthly checking of the safety valve.
Guide to replacing blown fuses for water and air pumps.
Steps for cleaning the water outlet strainer.
Procedure for using Chamber Brite for cleaning and descaling.
Instructions for cleaning the water sensor for accurate level reporting.
Solutions for when the autoclave fails to power on or operate.
Troubleshooting steps for the 'Low Heat' display.
Solutions for the 'Low Water' indicator.
Troubleshooting steps for the 'Low Pres' display.
Solutions for the 'Low Temp' indicator and potential causes.
Troubleshooting for 'High Temp' messages and sensor issues.
Solutions for the 'High Pres' display and potential causes.
Steps to resolve a clogged drain valve or line, and chamber fill issues.
General| Brand | Tuttnauer |
|---|---|
| Model | 2540EKA |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
