What to do if Tuttnauer 2450EK Laboratory Equipment displays ‘Low Water’?
If the 'Low Water' message is displayed on your Tuttnauer Laboratory Equipment, clean the water level electrode inside the vessel. Also, ensure the door is fully closed with the gasket properly seated, and check that the machine is level. Replace the door gasket if there's any steam leakage.
What to do when my Tuttnauer 2450EK displays ‘High Temp’?
If your Tuttnauer Laboratory Equipment displays ‘High Temp’, clean the air jet and check for proper voltage at the wall outlet.
What does ‘Low Heat’ mean on my Tuttnauer Laboratory Equipment?
If the message ‘Low Heat’ is displayed during heat up on your Tuttnauer Laboratory Equipment, it indicates a bad temperature sensor. If heating elements are remaining on instead of cycling on and off, call for a technician.
What to do if Tuttnauer 2450EK Laboratory Equipment printer prints blank paper?
If the printer of your Tuttnauer Laboratory Equipment prints, but nothing appears on the paper, ensure the paper is mounted correctly, as only one side is printable.
Why does my Tuttnauer 2450EK Laboratory Equipment display ‘Low Temp’?
If the 'Low Temp' message appears on your Tuttnauer Laboratory Equipment, refer to the solutions for the Low Water problem. Additionally, check if the sterilization time is set too long, causing the chamber to run dry.
What to do if Tuttnauer Laboratory Equipment chamber is not filling?
If your Tuttnauer Laboratory Equipment chamber is not filling, check the water level in the reservoir and for any obstructions blocking the pickup tube. Clean the water sensor and try filling the machine manually using the Manual Inlet key.
Why does the exhaust stage take so long when running a cycle on my Tuttnauer 2450EK Laboratory Equipment?
If you are running a ‘glassware’ program on your Tuttnauer Laboratory Equipment, this is normal. The slow exhaust will take between 15 and 20 minutes.
Why is there a loud noise coming from the reservoir of my Tuttnauer Laboratory Equipment?
If there is a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature might be set too high. The maximum setting is 274ºF (134ºC).
Why does Tuttnauer Laboratory Equipment exhaust stage take so long?
If the exhaust stage of your Tuttnauer Laboratory Equipment cycle is taking a very long time, it's normal if you are running a ‘liquids’ program. The slow exhaust can take between 15 and 20 minutes.
How to clean a very dirty Tuttnauer Laboratory Equipment chamber?
To clean a very dirty chamber in your Tuttnauer Laboratory Equipment, use Chamber Brite ™. Very dirty machines may require two cleanings.
General| Brand | Tuttnauer |
|---|---|
| Model | 2450EK |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
