Why are wraps burned after using Tuttnauer 2340EA?
To address wraps coming out burned from your Tuttnauer Laboratory Equipment, check if the water sensor is dirty. Also, verify that the wall outlet voltage is not too high and ensure items are not touching the chamber walls or bottom. Load the autoclave according to the instructions.
What to do when my Tuttnauer Laboratory Equipment displays ‘High Temp’?
If your Tuttnauer Laboratory Equipment displays ‘High Temp’, clean the air jet and check for proper voltage at the wall outlet.
What does ‘Low Heat’ mean on my Tuttnauer 2340EA Laboratory Equipment?
If the message ‘Low Heat’ is displayed during heat up on your Tuttnauer Laboratory Equipment, it indicates a bad temperature sensor. If heating elements are remaining on instead of cycling on and off, call for a technician.
How to clean a very dirty chamber in my Tuttnauer Laboratory Equipment?
If the chamber of your Tuttnauer Laboratory Equipment is very dirty, use Chamber Brite ™ to clean the autoclave; very dirty machines may require two cleanings.
Why are instruments rusting in my Tuttnauer 2340EA?
If instruments are rusting after sterilization in your Tuttnauer Laboratory Equipment, first determine if it's true rust by using a pencil eraser to remove the brown spot. If there is no pitting, the instrument is just dirty. Use distilled water for sterilizing and ensure dissimilar metals are not in contact with each other.
Why does Tuttnauer 2340EA Laboratory Equipment printer feed paper constantly?
If the printer on your Tuttnauer Laboratory Equipment gives paper feeds all the time when the machine is switched on, make sure the ‘feed button’ on the printer is not stuck.
What to do if the keyboard of my Tuttnauer 2340EA does not respond?
If the keyboard of your Tuttnauer Laboratory Equipment does not respond, press the STOP key for 2 seconds to abort any program that may still be running.
How to troubleshoot a Tuttnauer 2340EA Laboratory Equipment system that shows no response when turned on?
If your Tuttnauer Laboratory Equipment does not respond when you turn it on, try the following: First, check and fix all connections. If the issue persists, replace any faulty cables, connectors, or the power switch.
Why is my Tuttnauer 2340EA making a loud noise?
If you hear a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature may be set too high. The maximum setting is 274ºF (134ºC).
How to clean a very dirty Tuttnauer 2340EA Laboratory Equipment chamber?
To clean a very dirty chamber in your Tuttnauer Laboratory Equipment, use Chamber Brite ™. Very dirty machines may require two cleanings.
Explains common error messages, warning messages, and associated safety measures.
Details the four sterilization programs, their settings, and operational sequences.
Covers electrical connection requirements, safety, and compliance with regulations.
Details the crucial chamber pitch adjustment for older units and its impact on operation.
Instructions on cleaning, rinsing, and drying instruments before sterilization.
Guidance on packaging methods, tray placement, and preventing issues like water accumulation.
Advice on handling specific materials, preventing cross-contamination, and ensuring proper exposure.
Steps before starting operation, including water filling, power connection, and program selection.
How to start a cycle, monitor its progress, and understand indicator lights.
Outlines daily, weekly, and periodic maintenance tasks for optimal performance.
Solutions for unresponsive machines and 'Low Heat' error messages.
Troubleshooting for 'Low Water' and 'Low Pres' messages, including door seal checks.
Addresses 'Low Temp'/'High Temp' errors and common printer operational issues.
General| Type | Autoclave |
|---|---|
| Power | 1200 W |
| Frequency | 50/60 Hz |
| Chamber Material | Stainless Steel |
| Sterilization Time Range | 3 - 30 minutes |
| Warranty | 1 year |
| Cycle Time | 30 minutes |
| Sterilization Temperature Range | 121°C to 134°C |
To Next Page
