How to fix a Tuttnauer 2340EA chamber that is not filling?
If the chamber of your Tuttnauer Laboratory Equipment is not filling, check the water level in the reservoir. Also, inspect the bottom of the reservoir for any obstruction blocking the pickup tube. Clean the water sensor and try filling the machine manually using the Manual Inlet key.
Why is the drying cycle taking so long in my Tuttnauer Laboratory Equipment?
If the drying cycle in your Tuttnauer Laboratory Equipment is taking too long, the autoclave may be overloaded. Also, consider replacing the HEPA filter.
Why does the exhaust stage take so long when running a cycle on my Tuttnauer 2340EA Laboratory Equipment?
If you are running a ‘glassware’ program on your Tuttnauer Laboratory Equipment, this is normal. The slow exhaust will take between 15 and 20 minutes.
Why is there a loud noise coming from the reservoir of my Tuttnauer Laboratory Equipment?
If there is a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature might be set too high. The maximum setting is 274ºF (134ºC).
How do I fix a Tuttnauer Laboratory Equipment printer that doesn't print?
If the printer of your Tuttnauer Laboratory Equipment does not print, ensure the paper is inserted in the printer. If the printer prints a test printout, the printer is O.K. and there is a problem with the electronics. Contact your dealer to solve the problem. If the printer does not print the test printout, there is a problem with the printer. Contact your dealer to solve the problem.
Explains common error messages, warning messages, and associated safety measures.
Details the four sterilization programs, their settings, and operational sequences.
Covers electrical connection requirements, safety, and compliance with regulations.
Details the crucial chamber pitch adjustment for older units and its impact on operation.
Instructions on cleaning, rinsing, and drying instruments before sterilization.
Guidance on packaging methods, tray placement, and preventing issues like water accumulation.
Advice on handling specific materials, preventing cross-contamination, and ensuring proper exposure.
Steps before starting operation, including water filling, power connection, and program selection.
How to start a cycle, monitor its progress, and understand indicator lights.
Outlines daily, weekly, and periodic maintenance tasks for optimal performance.
Solutions for unresponsive machines and 'Low Heat' error messages.
Troubleshooting for 'Low Water' and 'Low Pres' messages, including door seal checks.
Addresses 'Low Temp'/'High Temp' errors and common printer operational issues.
General| Type | Autoclave |
|---|---|
| Power | 1200 W |
| Frequency | 50/60 Hz |
| Chamber Material | Stainless Steel |
| Sterilization Time Range | 3 - 30 minutes |
| Warranty | 1 year |
| Cycle Time | 30 minutes |
| Sterilization Temperature Range | 121°C to 134°C |
To Next Page
