How to fix a Tuttnauer Laboratory Equipment chamber that is not filling?
If the chamber of your Tuttnauer Laboratory Equipment is not filling, check the water level in the reservoir. Also, inspect the bottom of the reservoir for any obstruction blocking the pickup tube. Clean the water sensor and try filling the machine manually using the Manual Inlet key.
Why is the drying cycle taking so long in my Tuttnauer 2540EKA Laboratory Equipment?
If the drying cycle in your Tuttnauer Laboratory Equipment is taking too long, the autoclave may be overloaded. Also, consider replacing the HEPA filter.
Why does the exhaust stage take so long when running a cycle on my Tuttnauer Laboratory Equipment?
If you are running a ‘glassware’ program on your Tuttnauer Laboratory Equipment, this is normal. The slow exhaust will take between 15 and 20 minutes.
Why is there a loud noise coming from the reservoir of my Tuttnauer 2540EKA Laboratory Equipment?
If there is a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature might be set too high. The maximum setting is 274ºF (134ºC).
How do I fix a Tuttnauer 2540EKA printer that doesn't print?
If the printer of your Tuttnauer Laboratory Equipment does not print, ensure the paper is inserted in the printer. If the printer prints a test printout, the printer is O.K. and there is a problem with the electronics. Contact your dealer to solve the problem. If the printer does not print the test printout, there is a problem with the printer. Contact your dealer to solve the problem.
Specifies acceptable physical and chemical characteristics for water.
Step-by-step guide for replacing the HEPA air filter.
Procedure for emptying and cleaning the water reservoir.
Instructions for cleaning the air jet to ensure proper operation.
How to remove and install a new door gasket.
Procedure for monthly checking of the safety valve.
Guide to replacing blown fuses for water and air pumps.
Steps for cleaning the water outlet strainer.
Procedure for using Chamber Brite for cleaning and descaling.
Instructions for cleaning the water sensor for accurate level reporting.
Solutions for when the autoclave fails to power on or operate.
Troubleshooting steps for the 'Low Heat' display.
Solutions for the 'Low Water' indicator.
Troubleshooting steps for the 'Low Pres' display.
Solutions for the 'Low Temp' indicator and potential causes.
Troubleshooting for 'High Temp' messages and sensor issues.
Solutions for the 'High Pres' display and potential causes.
Steps to resolve a clogged drain valve or line, and chamber fill issues.
General| Brand | Tuttnauer |
|---|---|
| Model | 2540EKA |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
