What to do if Tuttnauer Laboratory Equipment displays ‘Low Water’?
If your Tuttnauer Laboratory Equipment displays a ‘Low Water’ message, you should: 1. Verify that there is water in the reservoir, and add water if needed. 2. Clean the water level electrode inside the vessel. 3. Check the leveling of the machine.
What to do if Tuttnauer 3870 EL displays ‘Low Pres’?
If the Tuttnauer Laboratory Equipment displays ‘Low Pres’, verify that no instruments are in contact with the water level electrodes. Also, check the door for leakage and replace the door gasket if necessary.
What to do if Tuttnauer 3870 EL displays ‘High Pres’?
If the Tuttnauer Laboratory Equipment displays ‘High Pres’, clean the water level electrode inside the vessel. Also, check the levelling of the machine.
What to do if Tuttnauer Laboratory Equipment is not responding?
If the Tuttnauer Laboratory Equipment is not responding, you should: 1. Check the outlet and verify that the voltage requirements have been met, including phase. 2. Ensure the main switch is in the ‘On’ position. 3. Confirm the power cord is properly connected to both the machine and the mains.
Why is Tuttnauer 3870 EL Laboratory Equipment leaking at the door?
If the Tuttnauer Laboratory Equipment is leaking at the door, make sure the door is tightened enough. If the leaking continues, replace the door gasket.
What to do if Tuttnauer 3870 EL displays ‘High Temp’?
If the Tuttnauer Laboratory Equipment displays ‘High Temp’, clean the water level electrode inside the vessel and check the leveling of the machine.
What to do if Tuttnauer Laboratory Equipment displays ‘Low Heat’?
If the Tuttnauer Laboratory Equipment displays ‘Low Heat’, make sure the machine has the proper amount of sterilization load and is not overloaded.
How to fix Tuttnauer Laboratory Equipment when the printer prints but nothing is on the paper?
If the printer prints, but nothing appears on the paper, ensure the paper is mounted correctly, as only one side is printable. Also, make sure the paper is inserted in the printer. If the issue persists, switch off the machine and switch it back on while pressing the feed button on the printer. If a test printout appears, the printer is working, and there may be an electronics issue.
Why Tuttnauer Laboratory Equipment water does not exit chamber?
If water does not exit the chamber of your Tuttnauer Laboratory Equipment due to a clogged outlet strainer, clean the strainer according to the instructions.
What to do if Tuttnauer 3870 EL Laboratory Equipment printer does not print?
If the printer does not print, switch off the Tuttnauer Laboratory Equipment and switch it back on while pressing the feed button on the printer. If the printer still does not print the test printout, there is a problem with the printer.
General| Door Type | Manual |
|---|---|
| Type | Autoclave |
| Power | 1.5 kW |
| Programs | 4 Pre-set cycles |
| Safety Features | Over-temperature protection |
To Next Page