What does 'Air Error' mean on Tuttnauer 3850 EL-D?
The 'Air Error' message on your Tuttnauer Laboratory Equipment appears at the end of the cycle if the autoclave does not reach atmospheric pressure after 10 minutes. To resolve this, wait until the autoclave reaches atmospheric pressure and then perform a new cycle.
What to do if Tuttnauer 3850 EL-D displays 'Cycle Failed'?
If your Tuttnauer Laboratory Equipment displays 'Cycle Failed', perform a new cycle.
What does 'RTC Error - Please Set Current Date and Time' mean on Tuttnauer Laboratory Equipment?
If your Tuttnauer Laboratory Equipment displays 'RTC Error - Please Set Current Date and Time', set the current date and time. If the problem persists, it may require technical assistance.
What to do if Tuttnauer 3850 EL-D Laboratory Equipment says 'Door is open (During the cycle)'?
If your Tuttnauer Laboratory Equipment shows 'Door is open (During the cycle)', close the door to perform a new cycle.
How to fix a Tuttnauer Laboratory Equipment machine that is not responding?
If your Tuttnauer Laboratory Equipment machine is not responding, check the following: 1. Ensure the main switch is in the ‘On’ position. 2. Verify the power cord is properly connected to both the machine and the mains. 3. Check if the circuit breaker has tripped; if so, lift the circuit breaker lever.
What to do if Tuttnauer 3850 EL-D Laboratory Equipment shows a 'No Water' message?
If your Tuttnauer Laboratory Equipment displays a 'No Water' message, it means the electrode in the chamber didn't detect water in time. To resolve this: 1. Check and fix the mineral-free water supply. 2. Check and clean the water inlet filter. 3. Clean the water level electrode.
What does 'Low Vacuum' mean on Tuttnauer 3850 EL-D Laboratory Equipment?
The 'Low Vacuum' message on your Tuttnauer Laboratory Equipment indicates that a vacuum level of 15kPa was not reached within 20 minutes after the cycle started during the air removal stage. To address this: 1. Try performing a new cycle. 2. If the issue persists, it may require technical assistance. 3. The bio-hazard filter may be clogged, requiring technical service since the door cannot be opened until a successful cycle is completed.
Why is my Tuttnauer 3850 EL-D Laboratory Equipment printer not printing?
If the printer on your Tuttnauer Laboratory Equipment is not printing, it could be due to the following reasons: 1. The printer might be out of paper. 2. As a general solution, try switching the machine off and then back on to restart it.
What does 'High Temp' mean on Tuttnauer Laboratory Equipment?
The 'High Temp' message on your Tuttnauer Laboratory Equipment indicates that the temperature rose 7°F (4°C) above the sterilization temperature for 2 seconds during the sterilization cycle. To resolve this, perform a new cycle.
What does 'Low Temp' mean on Tuttnauer 3850 EL-D Laboratory Equipment?
The 'Low Temp' message on your Tuttnauer Laboratory Equipment means that the temperature dropped for more than 1 second below the sterilization temperature during the sterilization cycle. To fix this, perform a new cycle.
Essential safety guidelines for operating, handling, and preventing hazards with the autoclave.
Identification of panel components and operation of the control panel keyboard.
Explanation of operational messages, error codes, and symbols on the display.
Details for Glass, Plastic, Liquid A, Liquid B, and Cooling programs.
Settings for Bio Hazard 1, 2, and Liquids programs.
Displays and warnings indicating aborted or failed sterilization cycles.
Procedures for starting, stopping, managing cycles, and unloading.
General| Brand | Tuttnauer |
|---|---|
| Model | 3850 EL-D |
| Category | Laboratory Equipment |
| Language | English |
To Next Page