Why are wraps burned after using Tuttnauer Laboratory Equipment?
To address wraps coming out burned from your Tuttnauer Laboratory Equipment, check if the water sensor is dirty. Also, verify that the wall outlet voltage is not too high and ensure items are not touching the chamber walls or bottom. Load the autoclave according to the instructions.
What to do when my Tuttnauer 3850EA displays ‘High Temp’?
If your Tuttnauer Laboratory Equipment displays ‘High Temp’, clean the air jet and check for proper voltage at the wall outlet.
What does ‘Low Heat’ mean on my Tuttnauer 3850EA?
If the message ‘Low Heat’ is displayed during heat up on your Tuttnauer Laboratory Equipment, it indicates a bad temperature sensor. If heating elements are remaining on instead of cycling on and off, call for a technician.
How to clean a very dirty chamber in my Tuttnauer 3850EA Laboratory Equipment?
If the chamber of your Tuttnauer Laboratory Equipment is very dirty, use Chamber Brite ™ to clean the autoclave; very dirty machines may require two cleanings.
Why are instruments rusting in my Tuttnauer Laboratory Equipment?
If instruments are rusting after sterilization in your Tuttnauer Laboratory Equipment, first determine if it's true rust by using a pencil eraser to remove the brown spot. If there is no pitting, the instrument is just dirty. Use distilled water for sterilizing and ensure dissimilar metals are not in contact with each other.
Why does Tuttnauer 3850EA Laboratory Equipment printer feed paper constantly?
If the printer on your Tuttnauer Laboratory Equipment gives paper feeds all the time when the machine is switched on, make sure the ‘feed button’ on the printer is not stuck.
What to do if the keyboard of my Tuttnauer 3850EA does not respond?
If the keyboard of your Tuttnauer Laboratory Equipment does not respond, press the STOP key for 2 seconds to abort any program that may still be running.
How to troubleshoot a Tuttnauer 3850EA Laboratory Equipment system that shows no response when turned on?
If your Tuttnauer Laboratory Equipment does not respond when you turn it on, try the following: First, check and fix all connections. If the issue persists, replace any faulty cables, connectors, or the power switch.
Why is my Tuttnauer Laboratory Equipment making a loud noise?
If you hear a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature may be set too high. The maximum setting is 274ºF (134ºC).
How to clean a very dirty Tuttnauer 3850EA chamber?
To clean a very dirty chamber in your Tuttnauer Laboratory Equipment, use Chamber Brite ™. Very dirty machines may require two cleanings.
Inspect the autoclave upon arrival for any signs of damage.
Details the instrument's warranty coverage for defects in material and workmanship.
Specifies the physical characteristics and acceptable contaminant levels for water used.
Details the program keys and other operational keys on the control panel.
Lists and explains various error messages and safety precautions.
Covers electrical connection requirements, safety relays, and compliance with regulations.
Covers placement of indicators, spore tests, and proper load arrangement.
Guides on initial setup, filling reservoir, and starting the autoclave.
Outlines routine maintenance tasks for daily, weekly, and periodic intervals.
Explains the importance and procedure for cleaning the air jet to prevent failures.
Details the procedure for cleaning the autoclave using Chamber Brite cleaner.
Provides solutions for the machine not responding and 'Low Heat' errors.
Offers solutions for 'Low Water', 'Low Pres', and 'Low Temp' error messages.
Addresses 'High Temp' errors, printer issues, and door leaks.
Solves issues like long heat-up, long exhaust, and clogged strainers.
General| Voltage | 230V |
|---|---|
| Frequency | 50/60 Hz |
| Type | Autoclave |
| Chamber Volume | 85 liters |
| Material | Stainless steel |
| Cycle Time | Varies depending on cycle parameters |
To Next Page
