How to fix Tuttnauer 3850 ELVG-D printer that doesn't print anything on the paper?
If your Tuttnauer Laboratory Equipment printer prints, but nothing appears on the paper, it likely means the paper roll isn't installed correctly. Ensure you install the paper roll the right way, noting that only one side of the paper is printable.
What to do if my Tuttnauer 3850 ELVG-D displays 'Heat Time Error'?
If your Tuttnauer Laboratory Equipment displays 'Heat Time Error', it means the system couldn't reach the required temperature in the chamber within the preset time. Try performing a new cycle. If the problem continues, call a technician.
What does 'Low Temp' mean on my Tuttnauer 3850 ELVG-D Laboratory Equipment?
If your Tuttnauer Laboratory Equipment displays 'Low Temp', it indicates that the temperature dropped below the sterilization temperature for more than 1 second during the sterilization cycle. Try performing a new cycle.
Why is the air detector failing in my Tuttnauer Laboratory Equipment?
If the air detector fails, consider the following possible causes: * The steam quality might not be proper. Check the steam quality and non-condensable gases. * The induced air valve might be open or leaking. Close or repair the induced air valve.
What to do if my Tuttnauer 3850 ELVG-D printer does not print?
If the printer on your Tuttnauer Laboratory Equipment isn't printing, first ensure that the paper roll is properly inserted. If it still doesn't print and there's no obvious reason, try switching the machine off and then back on to restart it.
Why are my Tuttnauer Laboratory Equipment sterilization results unsatisfactory?
If you're experiencing unsatisfactory sterilization results, consider the following possible causes: * There might be incomplete removal of air pockets. * Sterilization conditions might involve improper temperature or pressure being too low, or the sterilization time being too short. Set the correct temperature and time according to the type and quantity of material. * Incorrect loading of the autoclave may be trapping air in the load.
What does 'RTC Error - Please Set Current Date and Time' mean on my Tuttnauer 3850 ELVG-D?
If your Tuttnauer Laboratory Equipment displays 'RTC Error - Please Set Current Date and Time', it means you need to set the current date and time. If the problem persists after setting the date and time, call a technician.
What does 'Compresse d air supply error (ELVCPVG- D only)' mean on Tuttnauer Laboratory Equipment?
If your Tuttnauer Laboratory Equipment displays 'Compresse d air supply error (ELVCPVG- D only)', it indicates a compressed air supply malfunction. Check and fix the compressed air supply.
What to do if Tuttnauer Laboratory Equipment control unit does not initialize?
If the control unit doesn't initialize, showing no display or lights on the front panel, it could be due to: * The control circuit breaker being switched off. Check and switch on the circuit breaker. * Defective power switches on the front panels of the autoclave or steam generator. Replace the defective switch.
What does 'High Pressure (Ending)' mean on my Tuttnauer Laboratory Equipment?
If your Tuttnauer Laboratory Equipment displays 'High Pressure (Ending)', it means the system couldn't reach atmospheric pressure ± 10kPa during the ending stage. Perform a new cycle.
Information on display screens, operational messages, and error displays.
Displays for aborted, canceled, or failed sterilization cycles.
Changing operational parameters, system settings, and maintenance procedures.
How to select programs, start cycles, and handle errors.
Safe procedures for unloading the autoclave and moving the device.
Preventive maintenance for daily, weekly, and periodic checks.
Solutions for machine not responding, printer malfunctions, and door leaks.
Troubleshooting for vacuum, temperature, pressure, supply, and sensor errors.
General| Type | Autoclave |
|---|---|
| Chamber Volume | 85 L |
| Power Supply | 220-240V, 50/60Hz |
| Chamber Material | Stainless Steel |
| Temperature Range | 105°C - 137°C |
| Safety Features | Safety valve, Door protection interlock, Overheat protection |
To Next Page
